TM 9-2320-211-20
b. Installation.
(3) On dual tank models, disconnect the
(1) Secure the pedal and bracket assembly to
auxiliary t a n k lines a s f o l l o w s ( f i g . 2 - 9 0 ) :
the floorboard with two screws and nuts.
D i s c o n n e c t t r a n s f e r p u m p f e e d line, vent line,
(2) Secure the linkage bracket to the floor-
electrical lead, and fuel feed line to main tank.
board with two screws and nuts.
NOTE
(3) Connect the pedal rod and washer to the
On vehicles with a braced fuel tank (fig. 2-
linkage bracket.
9 1 ) , it is necessary to remove the rein-
(4) Secure the rod assembly to the bracket
forcing brace before the fuel tank can be
removed. Remove the two bolts, nuts, and
with a bolt and nut.
(5) Attach the linkage to the fuel rack with the
washers that retain the brace.
pin and cotter key.
(4) On vehicles without braced support rails
(6) Attach the spring to the rod, and install
(fig. 2-91), remove the tank as follows: Remove the
the throttle assembly.
nut, washer, and cushion attaching the retaining
strap to the support rails. Remove the fuel tank.
2-85. Fuel Tank
a. Removal.
(1) Remove the drain plug and drain the fuel
tank (fig. 2-88).
(2) Disconnect the engine feed line, engine
return line, vent line, electrical lead and, on dual
tank models, the fuel transfer line (fig. 2-89).
Fuel
tank.
F i g u r e 2-89. Main tank on M51A2 model.
