TM 9-2320-211-20
c. Installation.
(1) Use the three bolts and nuts to secure the
air tube to the right side panel (fig. 2-78). Connect
the ventilation line to the tube.
(2) Slip the rubber connector over the right
panel air tube end, and tighten the clamp (fig.2-
only.
77) securing the connector to the tube.
(2) Remove the nut and lockwasher securing
(3) Position the air cleaner on the fender (fig.
the shutoff control to the instrument panel. Pull the
2-76), and secure the cleaner unit to the fender with
control from the panel (fig. 2-80).
four bolts, lockwashers, and nuts.
(4) Install two rubber connectors onto the air
tube, and secure the connectors to the tube by
tightening the two clamps.
(5) Position the two connectors and the air
tube assembly, and secure them with clamps (fig. 2-
( 6 ) Push the air cleaner element into the
housing. Position and turn the locking mechanism
clockwise until the mechanism is secured in place
by the clamps (fig. 2-73).
(7) Secure the cover to the air cleaner with the
three latches.
2-78. Low Pressure Lines--Diesel and
Multifuel
a. General. Only the removal of the low pressure
fuel lines not adversely affected by minor con-
tamination is allocated to organizational main-
tenance. On multifuel engines these lines include all
(3) Remove the fuel shutoff valve (fig. 2-181).
but the final fuel filter-to-injection pump and its
bypass line.
b. Removal. Refer to paragraph 2 - 4 8 a .
Models.
a. Removal.
(1) Loosen the setscrew securing the control
wire to the fuel rack lever (fig. 2-79).
