TM 9-2320-211-20
2-83. Throttle Linkage--Diesel and Multifuel
CAUTION
Models
Cover all items until they are installed to
prevent contamination by dust or dirt.
d. Installation.
a. Removal.
(1) Position a new secondary or final element
(1) Remove the screw from the connector
attaching the throttle control wire to the throttle
( 2 ) Use new gaskets when installing the
rod assembly.
primary element and housing assembly.
(2) Loosen the clamp holding the control wire
( 3 ) Install the filter drainplugs. Start the
housing to the firewall.
engine and allow it time to warm up. Check all
(3) Remove the screw and washer attaching
filters for leaks. Tighten where necessary.
the throttle control handle to the instrument panel,
and pull the throttle control assembly through the
instrument panel into the cab.
b. Installation.
(1) String the throttle control assembly
t h r o u g h the instrument panel, and secure the
control handle to the panel with a washer and
screw.
(2) Secure the control wire to the firewall with
the clamp.
(3) Attach the control wire to the throttle rod
with a screw.
engine LDS 465-1.
