TM 9-2320-211-20
b. I n s t a l l a t i o n .
b. Installation.
(1) Position the tank and retain it with the
(1) Secure the pump to the bracket with two
washers, screws, and nuts.
NOTE
(2) Connect the inlet and outlet line.
On those vehicles with a braced tank (fig.
(3) Connect the electrical lead.
2-91), secure the brace with two washers,
2-87. Manifold Heater Supply Valve and Fuel
bolts, and nuts.
Return Valve--Multifuel Models
( 2 ) Connect all auxiliary tank lines. This
a. Removal.
includes the fuel feed line, transfer pump feed line,
(1) Disconnect the electrical lead and inlet
and outlet lines from heater fuel supply valve
(3) Connect the main tank lines as follows:
Feed line, return line, vent line, and electrical lead
(4) Install the drain plug, and fill the tank
with fuel. Run the engine and check the tank and
line connections for leaks. If necessary, re-tighten
the connections.
a. Removal.
(1) Disconnect the electrical lead.
(2) Disconnect the inlet and outlet line.
(3) Remove the two screws, nuts and washers
attaching the pump to the bracket, and remove the
pump.
multifuel engine LDS 465-1.
(2) Remove the three capscrews and lock-
washers securing the flame heater fuel pump and
fuel filter bracket to the crankcase, and remove the