TM 9-2320-211-20
models.
Figure 2-94. Fuel solenoid values--multifuel
engine LDS 465-1.
b. Installation.
(1) Secure the supply and / or return valves to
the bracket (fig. 2-93).
(2) Secure the fuel pump and filter bracket to
the crankcase with the three lockwashers and cap
screws.
(3) Connect the electrical lead and fuel inlet
and outlet lines to the supply valve and / or return
(2) Installation. Position the spring, element,
valve (fig. 2-93).
and smaller element gasket in the housing (fig. 2-
2-88. Fuel Filters--Diesel Models
96). Place the larger housing-to-bracket gasket into
p o s i t i o n , and secure the filter assembly to the
a. M a i n t e n a n c e . Refer to TM 9-2320-211-10.
mounting bracket with the washer and bolt (fig. 2-
b. Primary Filter.
95).
(1) R e m o v a l . R e m o v e t h e b o l t a n d l o c k -
c. Secondary Filter.
washer securing the filter to mounting bracket (fig.
(1) R e m o v a l .
2-95). Remove the filter assembly, and pull the two
(a) Open the pet cock and drain the fuel
gaskets, element, and spring out of the housing (fig.
into a suitable container (fig. 2-97).
2-96). Discard the gaskets.
(b) Disconnect the fuel line at the cover
elbow (fig. 2-97).
