TM 9-2320-366-20-3
10-6. SPINDLE REPLACEMENT
This task covers:
a. Removal
c. Installation.
b. Cleaning/Inspection
d. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Tools and Special Tools
Engine shut down (TM 9-2320-366-10-1)
Goggles, Industrial (Item 15, Appendix C)
Cab raised (TM 9-2320-366-10-1)
Jack, Hydraulic, Hand (Item 21, Appendix C)
Air tanks drained (TM 9-2320-366-10-1)
Tool Kit, Genl Mech (Item 46, Appendix C)
Wheel and tire removed (TM 9-2320-366-10-1)
Trestle, Motor Vehicle Maintenance (Item 47, Appendix
Hub assembly drained (for front spindles only)
Wrench Set, Socket (Item 49, Appendix C)
Differential spider assembly removed (para 10-
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
3)
Wheel bearing/CTIS seal removed (para 10-2)
Materials/Parts
Front brake shoes removed (for front spindles
Antiseize Compound (Item 13, Appendix D)
only) (para 11-2)
Grease, Automotive and Artillery (GAA) (Item 22,
Rear brake shoes removed (for intermediate
and rear spindles only) (para 11-3)
Oil, Lubricating, Gear, 80W-90 (Item 40, Appendix D)
Front brake air chamber removed (for front
Rag, Wiping (Item 50, Appendix D)
spindles only) (para 11-7)
Sealing Compound (Item 57, Appendix D)
Rear brake air chambers removed (for
Solvent, Dry Cleaning (Item 65, Appendix D)
intermediate and rear spindles only) (para 11-
Retainer (Item 242, Appendix G)
8)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when working under vehicle due to the possibility of
falling debris. Failure to comply may result in injury to personnel.
NOTE
Front, intermediate, and rear spindles are removed the same way. Front left spindle shown.
Change 2
