TM 9-2320-366-20-3
NOTE
Note position and orientation of fitting(s)
prior to removal.
Steps (4) and (5) apply to front spindles
only.
(4) Remove fitting (3) from fitting (10).
(5) Remove fittings (4 and 10) from spindle (11).
NOTE
Step (6) applies to intermediate and rear
spindles only.
(6) Remove 45-degree fitting(5) from spindle (11).
WARNING
Do not hit spindle with a steel hammer to
remove. Damage to spindle can occur
and broken parts can get as projectiles.
Failure to comply may result in injury to
personnel or damage to equipment.
CAUTION
Do not pry spindle with a sharp tool. Damage
to the mounting surfaces can occur. Failure
to comply may result in damage to
equipment.
(7) Remove spindle (11) from hub assembly (9) and
axle shaft (12).
Change 2
10-25
