TM 9-2320-366-20-4
Section II.
MAINTENANCE PROCEDURES
REPLACEMENT
This task covers:
a. Removal
c. Installation
b. Cleaning/Inspection
d. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Wheel removed (TM 9-2320-366-10-2).
Wheel Bearing Shim Tool Rest (Item 11, Appendix E)
Differential spider assembly removed
Gage, Depth, Micrometer (Item 10, Appendix C)
Materials/Parts
Rag, Wiping (Item 50, Appendix D)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Adhesive (Item 5, Appendix D)
Gloves, Rubber (Item 13, Appendix C)
Tape, Duct (Item 67, Appendix D)
Goggles, Industrial (Item 15, Appendix C)
Solvent, Dry Cleaning (Item 65, Appendix D)
Trestle, Motor Vehicle Maintenance (Item 106,
Grease, Automotive and Artillery (GAA) (Item 22,
Jack, Hydraulic, Hand (Item 21, Appendix C)
Seal Assembly, CTIS (2) (Item 266, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix
Seal Assembly, Hub (Item 267, Appendix G)
Socket, Socket Wrench (Item 72, Appendix B)
Personnel Required
CTIS Seal Driver (Item 19, Appendix E)
(2)
Wheel Hub Grease Seal Driver (Item 20,
a. Removal.
WARNING
Wheel drum weighs approximately 90 lbs
(41 Kgs). Use the aid of an assistant to
help remove wheel drum. Failure to
comply may result in injury to personnel.
NOTE
Front, intermediate, and rear axle wheel
bearings and CTIS seals are removed the
same way. Left front axle shown.
(1) Remove wheel drum (1) from wheel end hub (2).
