TM 9-2320-366-20-4
Section II. MAINTENANCE PROCEDURES
This task covers:
a. Removal
d. Adjustment
b. Inspection
e. Follow-On Maintenance
c. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Engine shut down (TM 9-2320-366-10-1).
Brake Adjusting Tool Support (Item E-2,
Tire removed (TM 9-2320-366-10-2).
Tools and Special Tools
Materials/Parts
Trestle, Motor Vehicle Maintenance (Item 47, Appendix
Rag, Wiping (Item 50, Appendix D)
Grease, Automotive and Artillery (GAA) (Item
Tool Kit, Genl Mech (Item 46, Appendix C)
22, Appendix D)
Tool, Spring Removal (Item 85, Appendix B)
Lockwasher (2) (Item 107, Appendix G)
Respirator, Air Filter (Item 29, Appendix C)
Adjusting Tool, Brake Shoe (Item 2, Appendix C)
Personnel Required
(2)
a. Removal.
WARNING
Wheel drum weighs approximately 90 lbs (41
kg). Use the aid of an assistant to help
remove wheel drum. Failure to comply may
result in injury to personnel.
Brake shoes may be covered with dust.
Breathing this dust may be harmful to your
health. Do not use compressed air to clean
brake shoes. Wear a filter mask approved
for use against brake dust.
Failure to
comply may result in injury to personnel.
(1) Remove wheel drum (1) from wheel hub (2).
