TM 9-2320-366-20-3
10-6. SPINDLE REPLACEMENT (CONT)
NOTE
Vehicles with greasable front drive flange do
not have felt seal or retainer.
(8) Remove retainer (13), thrust washer (14), sleeve
(15), and felt seal (16) from spindle (11). Discard
retainer.
b. Cleaning/Inspection
WARNING
Dry cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves;
use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not
breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flash
point for Type I dry cleaning solvent is 100 degrees F (38 degrees C) and for Type II is 130
degrees F (50 degrees C). Failure to comply may result in serious injury or death to
personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention. Failure to
comply may result in injury to personnel.
Compressed air used for cleaning purposes will not exceed 30 psi (207 km/h). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.).
Failure to comply may result in injury to personnel.
(1) Clean all metal parts with dry cleaning solvent and
dry using compressed air prior to inspection.
NOTE
Replace any part that fails visual inspection.
(2) Inspect spindle (1), sleeve (2), and thrust washer
(3) for cracks, pitting or corrosion.
10-26
Change 2
