TM 9-2320-366-20-4
b. Filling.
WARNING
Adhesives, solvents, and sealing com-
pounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water. Failure
to comply may result in injury to
personnel.
NOTE
Left and right bogie covers are installed the
same way. Left cover shown.
(1) Apply light bead of sealing compound to seating surface
of bogie housing (1).
(2) Install cover (2) on bogie housing (1) with matchmarks
aligned.
(3) Position six screws (3) in cover (2).
(4) Tighten six screws (3) to 24 lb-ft (33 Nm).
(5) Remove plugs (4 and 5) from bogie housing (1) and
cover (2).
(6) Fill bogie housing (1) with lubricating gear oil (Appendix
WARNING
Adhesive sealant MIL-S-46163 can damage
your eyes. Wear safety goggles/glasses
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water and get immediate medical
attention. Failure to comply may result in
injury to personnel.
(7) Apply sealing compound to threads of plugs (4 and 5).
(8) Install plugs (4 and 5) in bogie housing (1) and cover (2).
10-21
