TM 9-2320-260-34-2
Section VI. POWER DIVIDER AND DRIVE MAINTENANCE
16-46. POWER DIVIDER AND DRIVE MAINTENANCE INDEX
PAGE
PARA.
TITLE
NO.
NO.
Power Divider and Drive Replacement
Power Divider Repair
Drive Repair
Power Divider Governor Control Valve Replacement
16-47. POWER DIVIDER AND DRIVE REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM) (Contd)
APPLICABLE MODELS
TM 9-2320-260-20
M816
TM 9-2320-260-34P-2
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit
q Power divider and drive oil drained
(Appendix B, Item 1)
Lifting device
(LO 9-2320-260-12).
q Air reservoirs drained (TM 9-2320-260-10).
supports
q Transfer-to-power divider propeller shaft removed
MATERIALS/PARTS
(TM 9-2320-260-20).
Gasket (Appendix D, Item 102)
q Power divider-to-rear winch drive propeller shaft
Cotter pin (Appendix D, Item 21)
removed (TM 9-2320-260-20).
Two locknuts (Appendix D, Item 182)
q Power divider-to-hydraulic pump propeller shaft
Two sleeves (Appendix D, Item 511)
removed (TM 9-2320-260-20).
Four cotter pins (Appendix D, Item 48)
GENERAL SAFETY INSTRUCTIONS
Six lockwashers (Appendix D, Item 224
q Do not disconnect air lines before draining air
Six lockwashers (Appendix D, Item 215)
Antiseize tape (Appendix C, Item 50)
reservoirs.
q All personnel must stand clear during lifting
REFERENCES (TM)
operations.
LO 9-2320-261-12
q Ensure lifting capacity is greater than weight of
TM 9-2320-260-10
power cylinder.
1. Remove two cotter pins (1), control link (5), and two washers (6) from air valve (9). Discard
cotter pins (1).
2. Remove cotter pin (2), straight pin (7), two washers (3), and clevis (4) from control lever (8).
Discard cotter pin (2).
3. Remove cotter pin (14), straight pin (15), and control link (17) from control lever (16). Discard
cotter pin (14).
4. Remove cotter pin (13), straight pin (11), and control link (10) from control lever (12). Discard
cotter pin (13).
16-270
