TM 9-2320-260-34-2
16-47. POWER DIVIDER AND DRIVE REPLACEMENT (Contd)
WARNING
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
NOTE
Tag air lines for installation.
q
Perform steps 5 through 9 if replacing power divider.
q
5.
Remove air lines (7) and (8) and two sleeves (6) from elbow (5) and adapter (9). Discard sleeves (6).
Remove two locknuts (4), air valve (3), two spacers (2), and screws (1) from bracket (12). Discard
6.
locknuts (4).
Remove elbow (5) and adapter (9) from air valve (3).
7.
8.
Remove two screws (10), lockwashers (11), and bracket (12) from power divider (13). Discard
lockwashers (11).
Install two new lockwashers (11) and screws (10) on power divider (13).
9.
10.
Remove four screws (20), lockwashers (22), and cover (21) from tool box floor (16). Discard
Iockwashers (22).
11.
Attach lifting device to ring (15) of power divider (13).
WARNING
All personnel must stand clear during lifting operations.
q
A swinging or shifting load may cause injury to personnel.
Ensure lifting capacity is greater than weight (30 lb (14 kg)) of
q
power divider. Failure to do so may result in injury to personnel
or damage to equipment.
NOTE
Assistant will help with steps 12 through 16.
Position support under power divider (13).
12.
13.
Remove four nuts (19) and screws (14) from bracket (17) and tool box floor (16).
Lower power divider (13) and drive (18) on supports and secure with safety strap.
14.
Remove lifting device from ring (15) on power divider (13).
15.
16-272
