TM 9-2320-260-34-2
16-45. TRANSFER POWER TAKEOFF REPAIR (M815, M819) (Contd)
11.
Using arbor press, install new seal (10) in cover (8).
12.
Assemble shim pack (17) equal to thickness recorded in step 9 plus 0.002-0.005 in. (0.05-0.13 mm).
13.
Position two new gaskets (11), shim pack (17), and cover (8) on housing (1) with four new
lockwashers (18) and screws (9). Finger tighten screws (9).
14.
Install new gasket (16) and governor cover (15) on housing (1) with two new lockwashers (14) and
screws (13).
Install new woodruff key (12) in shaft (2).
15.
16.
Coat new seal (27) with gear oil and place in groove on shifter rod (26).
17.
Install shifter rod (26) and seal (27) in housing (1). Carefully work seal (27) into bore.
Place fork (19) in housing (1) and on shifter rod (26).
18.
19.
Holding fork (19) up, slide clutch (28) on shaft (2) and push clutch (28) in until fork (19) can set in
groove on clutch (28).
20.
Aline holes in fork (19) and shifter rod (26) and install setscrew (20).
Install plug (21) in housing (1).
21.
22.
Install ball bearing (25) and spring (24) in housing (1) with new lockwasher (23) and plug (22).
16-267
