TM 9-2320-240-34-2
16-50. POWER DIVIDER GOVERNOR CONTROL VALVE REPLACEMENT
THIS TASK COVERS:
c. Installation (M819)
a. Removal (M816)
d. Installation (39816)
b. Removal (M819)
MATERIALS/PARTS (Contd
APPLICABLE MODELS
M816, M819
Cotter pin (M819) (Appendix D, Item 40)
Antiseize tape (Appendix C, Item 50)
TOOLS
REFERENCES (TM)
General mechanic's tool kit
TM 9-2320-260-10
(Appendix B, Item 1)
TM 9-2320-260-34P-1
MATERIALS/PARTS
EQUIPMENT CONDITION
Two sleeves (Appendix D, Item 511)
Parking brake set (TM 9-2320-260-10).
Cotter pin (M816) (Appendix D, Item 40)
Air reservoirs drained (TM 9-2320-260-10).
Two locknuts (M816) (Appendix D, Item 169)
Two lockwashers (M816) (Appendix D, Item 215)
GENERAL SAFETY INSTRUCTIONS
Two locknuts (M819) (Appendix D, Item 182)
Do not disconnect air lines before draining air
Two locknuts (M819) (Appendix D, Item 171)
reservoirs.
WARNING
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
a. Removal (M816)
1. Remove air lines (9) and (10) and two sleeves (8) from elbow (7) and adapter (11). Discard sleeves (8).
2. Remove cotter pin (13), control link (16), and two washers (12) from air valve (5). Discard cotter
pin (13).
3. Remove two locknuts (6), air valve (5), two spacers (2), and screws (1) from bracket (18). Discard
locknuts (6).
4. Remove elbow (7) and adapter (11) from air valve (5).
5. Remove breather (3) and bushing (4) from air valve (5).
6. Remove two screws (14), lockwashers (15), and bracket (18) from power divider (17). Discard
lockwashers (15).
M816
16-299
