TM 9-2320-260-34-2
16-45. TRANSFER POWER TAKEOFF REPAIR (M815, M819) (Contd)
c. Assembly
NOTE
Coat all internal parts with-gear oil prior to assembly.
Install new woodruff key (7) in shaft (2).
1.
2.
Using
arbor press, install gear (4) and bearing (5) on shaft (2).
3.
Using
arbor press, install bearing (3) on shaft (2).
4.
Place
shaft (2) with bearings (3) and (5) and gear (4) in housing (1).
5.
Using
hammer and brass drift, install outer race (6) in housing (1) overbearing (5).
Install cover (8) on housing (1) with four screws (9). Finger tighten screws (9) to ensure cover (8)
6.
is positioned evenly.
7.
While turning shaft (2), tighten screws (9) until a slight drag is felt. Drag indicates there is zero
end play.
Using feeler gage, measure distance "d" between cover (8) and housing (1). Measure at three points
8.
approximately 120 apart. If measurements "d" vary by more than 0.003 in. (0.08 mm), loosen
screws (9) and repeat steps 7 and 8.
9.
Record measurement "d."
10.
Remove four screws (9) and cover (8) from housing (1).
16-266