C1, TM 9-2320-211-20
ORGANIZATIONAL M A I N T E N A N C E
INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF MATERIEL
Refer to TM 9-2320-211-10 for operating in-
structions, b r e a k - i n operating precautions, and
NOTE
If the vehicle has been driven to the using
break-in speeds. Whenever practical, the vehicle
operator will assist organizational maintenance
organization, m o s t o r a l l o f t h e a b o v e
procedures should have been performed.
personnel when performing these services.
d Follow the general procedures given in
2-2. Inspecting and
Servicing the Equipment
T M 9-2320-211-10.
e. Perform the S (6-month or 6,000 mile)
a. If any exterior surfaces are coated with
preventive-maintenance service (see instructions for
rust-preventive compound, remove it with
drycleaning solvent or mineral spirits paint thinner.
f. Lubricate those points illustrated in the
b . Read DD Form 1397 (Processing and
lubrication order regardless of interval, excluding
Deprocessing Record for Shipment, Storage, and
gear cases and engine. Check processing tag for
Issue of Vehicles and Spare Engines), and follow all
gear case and engine oil. If the tag states that the oil
precautions checked thereon. This tag should be
is suitable for 500 miles of operation and is of the
attached to the steering wheel, shifting levers, or
proper viscosity for local climatic operation, check
ignition switch.
the level but do not change the oil.
c. On processed materiel, when the engine
g. Schedule an S service on DD Form 314
has been stored for over 30 days, service the engine
( P r e v e n t i v e - M a i n t e n a n c e Schedule and Record
as outlined in TB ORD 392 by doing the
(card)) and arrange for an oil change at 500 miles.
following:
h. If the vehicle is delivered with a dry-
(l) Remove spark plugs from each cylinder.
charged battery, activate the battery in accordance
(2) Atomize spray 2 ounces of lubricating
w i t h TM 9-6140-200-15.
oil, (Military symbol PL Special) into each cylinder
2-3. Correction of
Deficiencies
through the spark plug opening.
(3) After an interval of 15 minutes, rotate
Deficiencies involving unsatisfactory design and
the engine by hand or starter for about 30 seconds
/ or materiel are to be reported as explained in TM
and reinstall the spark plugs.
38-750.
Deleted.
Deleted.
Section Il. REPAIR PARTS, SPECIAL TOOLS,
AND EQUIPMENT
b.. Special
.
specially designed for use by organizational level
a. Standard and commonly used tools and
e q u i p m e n t having general application to this
complete list of organizational maintenance tools
materiel are authorized for issue by tables of
are listed in TM 9-2320-211-20P, which is the
allowances (TA) and tables of organization and
authority for requesting replacements.
e q u i p m e n t (TOE).