TM 9-2320-366-20-4
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Engine shut down (TM 9-2320-366-10-1).
Goggles, Industrial (Item 15, Appendix C)
Socket Set, Impact (Item 33, Appendix C)
Wrench Set, Socket (Item 50, Appendix C)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C)
Materials/Parts
Nut, Self-Locking (2) (Item 161, Appendix G)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Left and right side rear axle shock absorbers are
removed the same way. Right side shown.
Perform step (1) on vehicle serial numbers 0001
through 1398, and 2988 and higher serial
numbers.
(1) Remove self-locking nut (1), bolt (2), and washer (3)
from rear axle shock absorber (4). Discard self-locking
nut.
15-6
