TM 9-2320-366-20-4
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Inspection
f. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Solvent, Dry Cleaning (Item 65, Appendix D)
Grease, Automotive and Artillery (GAA) (Item
22, Appendix D)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Nut, Self-Locking (4) (Item 162, Appendix G)
Goggles, Industrial (Item 15, Appendix C)
Nut, Self-Locking (8) (Item 154, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Nut, Self-Locking (8) (Item 156, Appendix G)
Trestle, Motor Vehicle Maintenance (2) (Item 47,
Nut, Self-Locking (2) (Item 160, Appendix G)
Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C)
Personnel Required
Socket, Socket Wrench (Item 70, Appendix B)
(2)
Wrench Set, Socket (Item 50, Appendix C)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Left and right sides of rear stabilizer bar are
disconnected the same way. Right side
shown.
(1) Position trestles under rear stabilizer bar (1).
15-9
