TM 9-2320-366-20-4
e. Front Angle Bracket Resilient Mount Removal.
NOTE
Left and right side front angle bracket
resilient mounts are removed the same way.
Right side shown.
Remove nut (1), spring washer (2), bolt (3), and
resilient mount (4) from front angle bracket (5).
Discard spring washer.
f. Front Angle Bracket Resilient Mount Installation.
NOTE
Left and right side front angle bracket
resilient mounts are installed the same way.
Right side shown.
(1) Position resilient mount (4) on front angle bracket
(5) with bolt (3), spring washer (2), and nut (1).
(2) Tighten nut (1) to 35-46 lb-ft (47-63 Nm).
g. Front Leaf Spring Resilient Mount Removal
WARNING
Use care when removing resilient mount
from leaf spring. Spring is under tension
and can act as a projectile if released.
Failure to comply may result in injury to
personnel or damage to equipment,
(1) Install C-Clamp on leaf spring (1)
NOTE
If vehicle has resilient mounts attached with
screws and washers, notify DS to install four
kits P/N 57K2003 on vehicle.
(2) Remove resilient mount (2) and spacer (3) from
bolt (4).
Change 2
