TM 9-2320-260-34-2
Section Il. REAR WINCH
16-7. REAR WINCH MAINTENANCE INDEX
PARA.
PAGE
TITLE
NO.
NO.
Rear Winch Repair
Rear Winch Level Wind Maintenance
Rear Winch Cable Tensioner Maintenance
Rear Winch Automatic Brake Maintenance
16-8. REAR WINCH REPAIR
THIS TASK COVERS:
a. Disassembly
c. Assembly
b. Cleaning, Inspection, and Repair
INITIAL SETUP
APPLICABLE MODELS
MATERIALS/PARTS (Contd)
M816
Two seals (Appendix D, Item 434)
Seal (Appendix D, Item 433)
TOOLS
Seal (Appendix D, Item 431)
General mechanic's tool kit
Three woodruff keys (Appendix D, Item 557)
(Appendix B, Item 1)
O-ring (Appendix D, Item 293)
Mechanical puller kit (Appendix B, Item 14)
GM grease (Appendix C, Item 14)
Spring tester (Appendix B, Item 10)
Gear oil (Appendix C, Item 22)
Inside micrometer (Appendix B, Item 9)
Rags (Appendix C, Item 32)
Vernier caliper (Appendix B, Item 33)
PERSONNEL REQUIRED
Outside micrometer (Appendix B, Item 8)
Two
Soft-head hammer (Appendix B, Item 47)
Arbor press (Appendix B, Item 7)
REFERENCES (TM)
MATERIALS/PARTS
LO 9-2320-260-12
Four cotter pins (Appendix D, Item 37)
TM 9-2320-260-20
Twenty Iockwashers (Appendix D, Item 223)
TM 9-2320-260-34P-2
Six lockwashers (Appendix D, Item 219)
EQUIPMENT CONDITION
Five lockwashers (Appendix D, Item 218)
Rear winch removed (TM 9-2320-260-20).
Six screw-assembled lockwashers
Rear winch level wind removed (para. 16-9).
Gear oil drained (LO 9-2320-260-12).
Two gaskets (Appendix D, Item 100)
Gasket (Appendix D, Item 98)
Gasket (Appendix D, Item 99)
a. Disassembly
1. Remove four cotter pins (8), two pins (7), and lever (5) from right bracket (6). Discard cotter pins (8).
2.
Remove two nuts (17), lockwashers (16), and screws (15) from bracket (12) and tensioner (11).
Discard lockwashers (16).
Remove four screws (13), lockwashers (14), and bracket (12) from winch (1). Discard lock-
3.
washers (14).
16-44
