TM 9-2320-260-34-2
16-8. REAR WINCH REPAIR (Contd)
28.
Using puller, remove rear bearing (1) from wormshaft (3).
29.
Remove wormshaft (3) with front bearing (4) from gearcase (2).
30.
Using puller, remove front bearing (4) from wormshaft (3).
31.
Remove seal (5), thrust washer (6), and sleeve (7) from end frame (8). Discard seal (5).
1. For general cleaning instructions, refer to para. 2-8.
2. For general inspection instructions, refer to para. 2-9.
3. For general repair instructions, refer to para. 2-10.
4. Inspect gearcase (2), gearcase bores (10), bushing (9), shaft (11), cover (12), and bushing (13) in
cover (12) for nicks, burrs, scores, cracks, breaks, and excessive wear. Refer to table 16-6, Rear
Winch Parts Wear Limits, for measurements. Replace or repair part(s) if damaged or worn.
NOTE
Perform steps 5 and 6 if gearcase bushing fails inspection.
q
Perform steps 7 and 8 if cover bushing fails inspection.
q
5. Using arbor press, remove bushing (9) from gearcase (2). Discard bushing (9).
6. Using arbor press, install new bushing (9) in gearcase (2).
16-48