TM 9-2320-260-34-2
16-6. FRONT WINCH DRAG BRAKE REPLACEMENT (Contd)
3. Remove nut (1) from end of tie rod (2).
NOTE
Place support beneath drum before removing end frame.
4. Remove end frame (8), clutch (4), thrust washer (5), and sleeve (6) from drum (3) and drum
shaft (13).
5. Remove adjusting screw (10), drag brake (12), and spring (11) from end frame (8).
b. Installation
Install spring (11) and drag brake (12) on end frame (8) with adjusting screw (10).
1.
Install clutch (4) on drum shaft (13).
2.
Install thrust washer (5) on drum shaft (13) against clutch (4).
3.
Install sleeve (6) in end frame (8). Ensure lugs of shift fork (9) engage grooves in sleeve (6).
4.
Install end frame (8) onto drum shaft (13) and tie rod (2), and seat toward drum (3).
5.
Operate shift handle (7) and ensure clutch (4) engages and disengages drum (3). If not, pull end
6.
frame (8) off and repeat steps 2 through 5.
7.
Install nut (1) on tie rod (2).
NOTE
Perform steps 8 and 9 if front winch is not equipped with level
wind mechanism.
8.
Install side channel (20) on end frame (8) and gearcase (17) with four new lockwashers (18) and
screws (19).
9.
Install top channel (14) on end frame (8) and gearcase (17) with four new lockwashers (16) and
screws (15).
16-42
