TM 9-2320-260-34-2
16-9. REAR WINCH LEVEL WIND MAINTENANCE
I
THIS TASK COVERS:
a. Removal
d. Assembly
e. Installation
b. Disassembly
c. Cleaning and Inspection
INITIAL SETUP
APPLICABLE MODELS
MATERIALS/PARTS (contd)
M816
Felt washer (Appendix D, Item 533)
Locknut (Appendix D, Item 183)
TOOLS
Locknut (Appendix D, Item 180)
General mechanic's tool kit
Felt seal (Appendix D, Item 478)
(Appendix B, Item 1)
GAA grease (Appendix C, Item 14)
Outside micrometer (Appendix B, Item 8)
Lubricating oil (Appendix C, Item 21)
Inside micrometer (Appendix B, Item 9)
REFERENCES (TM)
Arbor press (Appendix B, Item 7)
TM 9-2320-260-20
MATERIALS/PARTS
TM 9-2320-260-34P-2
Four lockwashers (Appendix D, Item 219)
EQUIPMENT CONDITION
Four lockwashers (Appendix D, Item 215)
Eight felt washers (Appendix D, Item 534)
Rear winch cable removed (TM 9-2320-260-20).
Remove four screws (2), lockwashers (3), and level wind (1) from rear winch (4). Discard lock-
washers (3).
I
b. Disassembly
I
NOTE
Record positions of retainer screws and stop screws for installation.
1.
Loosen four jamnuts (6) and remove four retainer screws (7) and jamnuts (6) from trolley (5).
2. Remove trolley (5) from track frame (9).
3. Loosen two jamnuts (8) and remove two stopscrews (16) and jamnuts (8) from track frame (9).
4. Remove two nuts (11) and latch (12) from poppet nut (13).
5. Remove poppet nut (13), spring (14), and poppet (15) from threaded bore (10) on track frame (9).
16-58
