C3, TM 9-2320-211-20
Figure 2-210. Removing hydraulic oil reservoir--multifuel
models.
ventilation line to the reservoir and tighten all
connectors.
(1) Support the reservoir in position, and secure the
(5) Install and tighten the drain plug.
reservoir to the left front fender splash shield with four
washers, two screws, and two safety nuts. Tighten the
(6) Fill the reservoir in accordance with LO 9-2320-
211-12. Check for possible leaks.
nuts.
(2) Install a spacer, washer, and one cushion to the
2-222.1. Steering Conversion Kit.
For installation
screw, and place the screw into the bracket hold at the
instructions refer to drawing 11672548 (8 sheets); for
bottom of the reservoir.
illustration to drawing 11672547 (4 sheets) and 11677197
(3) Secure the reservoir bracket to the frame left side
(5 sheets) and to 11672552(1 sheet) for template used in
rail with the other cushion and safety nut on the screw.
installation. Refer to TM 9-2320-260-20 for maintenance
Tighten the nut.
of steering conversion kit.
(4) Connect the outlet line, two inlet lines, and the
Section XXXIII. MAINTENANCE OF FRAME, TOWING
ATTACHMENTS, AND BRACKETS
2-224. Pintle Assembly.
2-223. General. The frame attachments and brackets
a. Hook.
discussed in this section include the towing pintle, the
(1) Service.
Periodically lubricate the pintle
lifting shackle assembly, the safety chain shackle
assembly in accordance with LO 9-2320-211-12.
assembly, and the fifth wheel assembly. The pintle hook
(2) Removal. Remove the cotter pin, slotted nut,
mounting bracket and safety chain shackle bracket are
and washer (from behind rear crossmember) securing the
bolted to the frame bumper (which is bolted to the
hook to the mounting bracket. Pull the hook from the
frame).