C3, TM 9-2320-211-20
b. Inspection. If it was necessary to remove the arm as
(3) Install the front end of the lower drag link on the
in a(3) above, each related part of the arm must be
lower ball stud at the relay lever.
(4) Install the front end of the upper drag link on the
tightening the nuts.
upper ball stud at the relay lever.
(5) Remove the screw from the outer end of the
relay pin and install the lubrication fitting in the hole in
2-222. Hydraulic Oil Reservoir.
the end of the pin. Lubricate the relay lever.
a. Maintenance. Service the reservoir in accordance
with LO 9-2320-211-12.
a. Adjustment.
(1) Remove plug (J) from bottom of the reservoir
CAUTION
(2) Disconnect the
ventilation line (B) fig. 2-209 by
unscrewing the connector.
If the steering knuckle arm is loose, this
(3) Disconnect the two inlet lines (K).
condition will be reported immediately to
(4) Disconnect the outlet line (L).
direct and general maintenance support
(5) Remove the screw, washer, two mount cushions,
personnel.
spacers, and safety nut securing the reservoir mounting
bracket to the frame left side rail.
(1) With front wheels on the ground, alternately
(6) While supporting the reservoir, remove the two
turn the steering wheel from right to left and observe any
nuts, two screws, and four washers securing the reservoir
movement of the arm on the steering.
to the left front fender splash shield. Remove the
(2) If the arm does not move, tighten the stud nuts.
reservoir.
(3) If the arm is loose, remove the arm.
Figure 2-209. Removing Hydraulic Oil Reservoir --
Gasoline and Diesel Models.