TM 9-2320-366-20-4
(20) Install tool box lid (35) in two hinges (27) with four
lockwashers (39) and self-locking nuts (40).
NOTE
Step (21) requires the aid of an assistant.
(21) Position stay (41) on tool box (9) with four screws (42),
washers (43), and self-locking nuts (44).
(22) Tighten four screws (42) to 8-10 lb-ft (11-13 Nm).
(23) Close tool box lid (35).
d. Installation.
WARNING
Rear tool box weighs approximately 75 lbs
(34 kgs) empty. Attach a suitable lifting
device prior to installation. Failure to
comply may result in injury to personnel
or damage to equipment.
NOTE
Both tool boxes are installed the same way.
Rear tool box shown.
Steps (1) and (2) require the aid of an assistant.
(1) Position tool box (1) on support structure (2).
Change 1
