TM 9-2320-366-20-4
16-23. M1089 TOOL BOX REPLACEMENT/REPAIR (CONT)
NOTE
Left and right tubes are removed the same
way. Right tube shown.
(12) Remove two self-locking nuts (31), four washers (32),
two screws (33), tube (34), and two clamps (35) from
tool box (6). Discard self-locking nuts.
(13) Remove nonmetallic bumper (36) from tool box (6).
Discard nonmetallic bumper.
NOTE
Perform steps (14) and (15) on front tool box.
(14) Remove self-locking nut (37) and screw (38) from
bracket (39). Discard self-locking nut.
(15) Remove self-locking nut (40), screw (41), washer (42),
and bracket (39) from front tool box (43). Discard self-
locking nut.
c. Assembly.
NOTE
Perform steps (1) and (2) on front tool box.
(1) Position bracket (1) on front tool box (2) with screw (3),
washer (4) and self-locking nut (5).
(2) Tighten self-locking nut (5) to 33-37 lb-ft (45-50 Nm).
(3) Position screw (6) in bracket (1) with self-locking nut (7).
(4) Tighten self-locking nut (7) to 17-19 lb-ft (23-26 Nm).
Change 1
