TM 9-2320-366-20-4
16-23. M1089 TOOL BOX REPLACEMENT/REPAIR (CONT)
(15) Install four hinges (27) on tool box (9) with four washers
(28) and self-locking nuts (29).
NOTE
All tool box lids, stays, and hasps are
installed the same way. Left rear shown.
(16) Position four hasps (30) on tool box (9) with 16 screws
(31), washers (32), and self-locking nuts (33).
(17) Tighten 16 self-locking nuts (33) to 12-24 lb-in. (1-3
Nm).
(18) Position two brackets (34) on tool box lid (35) with four
screws (36), washers (37), and self-locking nuts (38).
(19) Tighten four self-locking nuts to 12-24 lb-in. (1-3 Nm).
16-176
