TM 9-2320-366-20-4
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Nut, Self-Locking (4) (Item 168, Appendix G)
Cab air springs deflated (TM 9-2320-366-10-1).
Nut, Self-Locking (Item 133, Appendix G)
Spare tire lowered (TM 9-2320-366-10-2).
Nut, Self-Locking (8) (Item 156, Appendix G)
Tools and Special Tools
Personnel Required
Tool Kit, Genl Mech (Item 46, Appendix C)
(2)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C)
Socket Set, Socket Wrench (Item 36, Appendix C)
a. Removal.
(1) Match mark position of cab hydraulic latch (1) on rear
cab support (2).
(2) Remove four self-locking nuts (3), washers (4), screws
(5), and cab hydraulic latch (1) from rear cab support (2).
Discard self-locking nuts.
(3) Remove three screws (6), and cable clamps (7) from
rear cab support (2).
(4) Remove self-locking nut (8) and cab leveling valve
linkage (9) from rear cab support (2). Discard self-
locking nut.
Change 1
