TM 9-2320-366-20-4
NOTE
Steps (3) through (7) require the aid of an
assistant.
(3) Position door (7) on cab with hinge (1) in slot in
forward edge of door and bolt holes aligned with
openings in door.
(4) Position door (7) on hinge (1) with three washers
(8) and screws (9).
(5) Position door (7) on hinge (4) with three washers
(10) and screws (11).
(6) Position door (7) so that gap between door and cab
is approximately equal all around.
(7) Tighten three screws (9) and screws (11) one-half
turn.
(8) Open, close, and open door (7) to ensure correct
operation.
(9) Tighten three screws (9) and screws (11) to 22-26
lb-ft (30-35 Nm).
(9.1) Apply grease to hinges (1 and 4).
(10) Install four clip nuts (12) on door (7).
(11) Install wiring harness (13) through access hole in
forward edge of door (7).
Change 2
