TM 9-2320-366-20-4
(6) Position cab leveling valve linkage (5) on rear cab
support (1) with and self-locking nut (6).
(7) Tighten self-locking nut (6) to 84-108 lb-in. (9-12 Nm).
(8) Install three cable clamps (7) on cab support (1) with
screws (8).
(9) Position cab hydraulic latch (9) on rear cab support (1)
with matchmarks aligned.
(10) Position four screws (10), washers (11), and self-locking
nuts (12) in cab hydraulic latch (9).
(11) Tighten four self-locking nuts (12) to 34-44 lb-ft (46-60
Nm).
NOTE
Loosen screws only enough that latches can
be moved with some resistance.
(12) Loosen four screws (13) in two cab latches (14).
Change 1
