TM 9-2320-366-20-4
11-4. FRONT BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR (CONT)
NOTE
Align keyway in adjusting plunger with hole in
plunger housing.
(5) Install adjusting plunger (5) in plunger housing (6).
CAUTION
Ensure pawl enters adjusting plunger so that
adjusting plunger slides freely in plunger
housing. Failure to comply may result in
damage to equipment.
Ensure grooves on pawl engages grooves on
adjusting sleeve. Failure to comply may result
in damage to equipment.
(6) Position lockwasher (7) and adjusting pawl assembly (8)
in plunger housing (6).
(7) Tighten adjusting pawl assembly (8) to 15-25 lb-ft (20-34
Nm).
(8) Perform steps (5) through (7) on second adjusting
plunger assembly.
(9) Apply grease on wedge rollers (9).
CAUTION
Ensure wedge rollers are aligned with slots in
adjusting plungers. Firm pressure is required
to fully seat wedge in adjusting plungers.
Failure to fully seat wedge in adjusting
plungers may result in damage to equipment.
(10) Install wedge (10) in plunger housing (6).
f.
Follow-On Maintenance.
(1) Install front brake air chamber (para 11-7).
(2) Install front brake shoes (para 11-2).
End of Task.
