TM 9-2320-366-20-4
(4) Apply grease to inside surface of seal (3).
(5) Seat seal (3) on adjusting screw (4).
(6) Install adjusting screw (4) in adjusting sleeve (5).
Back off 1/4 turn.
(7) Apply film of grease on adjusting sleeve (5).
CAUTION
Ensure adjusting sleeve is installed in
adjusting plunger with large shouldered
end up. Failure to comply will cause self-
adjusting feature not to function.
Adjusting sleeve must bottom on shoulder
in adjusting plunger. If adjusting screw is
threaded too far into adjusting sleeve,
adjusting screw will bottom in adjusting
plunger and automatic adjustment will not
function.
(8) Install adjusting sleeve (5) in adjusting plunger (6).
(9) Apply film of grease on adjusting plunger (6).
(10) Perform steps (4) through (9) for other adjusting plunger
assembly.
CAUTION
e. Installation.
Anchor plunger marked "L" is for left plunger
housing. Anchor plunger marked "R" is for
right plunger housing. Failure to comply may
result in damage to equipment.
NOTE
Align keyway in anchor plunger with hole in
plunger housing.
(1) Install anchor plunger (1) in plunger housing (2).
(2) Position lockwasher (3) and guide screw (4) in
plunger housing (2).
(3) Tighten guide screw (4) to 15-25 lb-ft (20-34 Nm).
(4) Perform steps (1) through (3) on second anchor
plunger.
Change 2
