TM 9-2320-366-20-4
(5) Remove seal (5) from anchor plunger (6).
(6) Perform step (5) on second anchor plunger.
c. Cleaning/Inspection.
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe
vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for
Type I Dry Cleaning Solvent is 100F (38C) and for Type II Dry Cleaning Solvent is 130F
(50C). Failure to comply may result in serious injury or death to personnel.
If personnel become dizzy while using Dry Cleaning Solvent, immediately get fresh air and
medical help. If Dry Cleaning Solvent contacts skin or clothes, flush with cold water. If Dry
Cleaning Solvent contacts eyes, immediately flush eyes with water and get immediate medical
attention. Failure to comply may result in injury to personnel.
(1) Clean all metal parts thoroughly with dry cleaning
solvent.
NOTE
Replace plungers, sleeves, screws, springs,
and pawls as a unit.
(2) Inspect two adjusting plungers (1), adjusting sleeves (2),
and adjusting screws (3) for damage.
(3) Inspect two screws (4), springs (5), and adjusting pawls
(6) for damage.
11-19
