TM 9-2320-366-20-4
11-5. REAR BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR (CONT)
WARNING
Brake shoes may be covered with dust.
Breathing this dust may be harmful to
your health. Do not use compressed air
to clean brake shoes. Wear a filter mask
approved for use against brake dust.
Failure to comply may result in injury to
personnel.
NOTE
Identify anchor and adjusting plunger locations
prior to disassembly.
Anchor plungers and adjusting plungers are
opposite each other in each plunger housing.
The positions are reversed for opposite sides of
the wheel. Perform the following procedure to
disassemble both plunger assemblies.
(2) Remove guide screw (3) and lockwasher (4) from
plunger housing (5). Discard lockwasher.
(3) Remove seal (6) and anchor plunger (7) from plunger
housing (5).
(4) Remove adjusting pawl assembly (8) and lockwasher (9)
from plunger housing (5). Discard lockwasher.
(5) Remove seal (10), adjusting screw (11), and adjusting
plunger (12) from plunger housing (5).
11-24
