TM 9-2320-366-20-4
d. Assembly.
(1) Apply grease to inside surfaces of seal (1).
(2) Position and seat seal (1) on anchor plunger (2).
(3) Apply grease to inside surface of seal (3).
(4) Position and seat seal (3) on adjusting screw (4).
(5) Install adjusting screw (4) in adjusting sleeve (5) until
snug. Back off 1/4 turn.
(6) Apply film of grease on adjusting sleeve (5).
CAUTION
Ensure adjusting sleeve is installed in
adjusting plunger with large shouldered end
up.
Failure to comply will cause self-
adjusting feature not to function.
(7) Position adjusting sleeve (5) in adjusting plunger (6).
(8) Apply film of grease on adjusting plunger (6).
11-27
