TM 9-2320-211-20
a. General. The propeller shaft for the
hoisting system
transmits power from the power divider to the bevel gear
box.
b. One Section Shaft Removal.
(1) Disconnect the power takeoff-to-power divider
propeller shaft from the drive shaft yoke at the front of
the power divider.
(2) Disconnect the
rear winch front propeller shaft
from the winch output shaft yoke at the rear of the power
divider.
(3) Disconnect the power divider controls.
(4) Remove the patch plate above the power divider
assembly with a suitable lifting device as shown in figure
2-261.