C3, TM 9-2320-211-20
from the winch output shaft yoke at the rear of the power
(5) Remove the clamps and slide back the
divider.
(6) Connect the power takeoff-to-power divider
propeller shaft from the drive shaft yoke at the front of
(6) Remove the capscrews from the flange couplings
the power divider.
at each end of the propeller shaft.
(7) Loosen the power divider support bolts. Lower
(1) Remove four bolts from flanged disconnect of
the power divider slightly to provide clearance and
propeller shaft. Allow each half of shaft to swing down
permit removal of the propeller shaft from the seal
for removal clearance.
(2) Remove universal bearing dust seal from
c. One Section Shaft Installation.
housing.
(1) Install the propeller shafts in
position in
the seal
(3) Remove six screws securing universal bearing to
flange at each end of the propeller shaft.
(2) Raise the power divider up into position, tighten
the support bolts securely, remove the lifting device, and
(1) Position propeller shaft halves into seal
replace the patch plate above the power divider assembly
housings.
(2) Install six screws securing universal bearing to
(3) Install the capscrews in
the flange couplings at
flange at each end of the propeller shaft.
(3) Position universal bearing dust seal on seal
housing and secure with clamps.
clamps.
(4) Join propeller shaft halves at flanged disconnect
(4) Connect the power divider controls.
and tighten four bolts.
(5) Connect the rear winch front propeller shaft