C2,TM
9-2320-211-20
( 2 ) Remove the axle shaft by pulling on the
a. Removal
t h e flange gasket.
(1) R e m o v e t h e 1 0 s c r e w s a n d l o c k w a s h e r s
b. Installation.
h u b and drum assembly.
splined shaft end and hold the gasket in position on
the flange.
( 2 ) Insert the splined end of the shaft in the
hub. Push the axle drive flange inward toward the
center of the truck. Carefully guide the shaft
splined end into the splined differential side gear.
( 3 ) Aline the ten drive flange holes with the
t e n matching holes in the drum. Install 10 screws
Section XXIX. MAINTENANCE OF BRAKE SYSTEM
a. Service Brake System. Service brake com-
ponents include the pedal and linkage, master
cylinder,
air
hydraulic
cylinder,
wheel
cylinders,
connnecting lines and fittings for the hydraulic fluid,
and the brake.
b. Hand Brake. Handbrake
components
include
m o u n t e d at the rear of the transfer. I n addition, a
c a b l e is connected to the handbrake lever in the
cab. The drum is bolted to the transfer rear output
shaft. The two brakeshoes are pinned together and
then bolted to a bracket extending from the transfer
r e a r output shaft bearing cover.
Handbrake
mounted
to
rear
of
transfer.