TM 9-2320-211-20
2-170.3
Directional
Signal
Control
Indicator
Lamp
(Fig. 2 - 1 6 7 . )
a. R e m o v a l .
(1) U n s c r e w a n d r e m o v e t h e l a m p c o v e r
(lens).
(2) Remove the indicator lamp by pushing it
in and turning it counterclockwise.
b. Installation. Refer to the removal procedure,
and reverse the sequence.
removal and installation.
2 - 1 7 0 . 2 Directional
Signal Flasher Unit
2-166.)
(Fig.
a. Removal.
(1) Disconnect the electrical cable connector
from the side of the flasher unit.
(2) Remove the two screws and lockwashers
securing the flasher unit to the cab forward
bulkhead, and remove the directional signal flasher
removal and installation.
unit.
b. Installation. Refer to the removal procedure,
Restriction
Indicator--Diesel
and
and reverse the sequence.
Multifuel
a. R e m o v a l .
(1) Disconnect the air line at the rear of the
indicator.
(2) Remove the two nuts, screws, and washers
securing t h e indicator to the instrument panel.
R e m o v e the indicator.
b. I n s t a l l a t i o n .
(1) S e c u r e t h e r e s t r i c t i o n i n d i c a t o r t o t h e
i n s t r u m e n t panel with two screws, washers, and
n u t s . Tighten the nuts.
( 2 ) Connect the air line at the rear of the
indicator.
removal and installation.
