TM 9-2320-211-20
b. Removal.
g. Insert the ball stud on the front end of the
(1) Loosen the screw securing the collar (fig.
throttle cross-shaft-to-carburetor rod in the hole at
2-67) to the throttle control wire and remove the
the lower end of the throttle valve plate lever.
collar.
Install the nut on the stud at the back side of the
lever, and tighten the nut.
( 2 ) Loosen the nut and bolt securing the
throttle control supporting the bracket clip to the
supporting bracket, and remove the control from
NOTE
the clip.
The throttle control is in proper adjustment
(3) Pull the free end of the throttle through
when the accelerator linkage is properly
the rubber bushing in the cab cowl and into the cab.
adjusted and the throttle control can be
(4) Remove the jamnut and lockwasher from
pulled out approximately one-eighth inch
the throttle control at the back side of instrument
before starting to actuate the throttle valve
panel, and pull the throttle control from the front of
plate lever.
the instrument panel.
a. Adjustment.
c. Installation.
(1) Insert the throttle control in the hole in the
(2) Loosen the screw securing the collar (fig.
instrument panel and install the lockwasher and
2-67) to the throttle control wire.
jamnut on the throttle control at the back side of
(3) Position the collar on the throttle control
the instrument panel. Position the throttle control
wire. Maintain a clearance of approximately one-
knob so that the lettering on the face of the knob is
eighth inch between the top surface of the collar
in a vertical position, and tighten the jamnut.
and the underside of the cross-shaft link clip when
(2) Push the free end of the throttle control
the throttle valve plate lever is in the idling position,
through the bushing in the cab cowl.
and the throttle control knob is in against the in-
(3) Position the control under the throttle
strument panel as far as it will go.
control-supporting bracket clip, push the control
(4) Tighten the throttle control wire collar
wire through the hole in the forward end of the
screw.
cross-shaft link clip, and tighten the nut and bolt
securing the clip to the supporting bracket (fig. 2-
wire, and adjust the throttle control (a above).
2-69. Anti-diesel Control-Valve Integral with
Carburetor
a. Removal.
(1) Pull the cotter pin from the antidiesel
valve push rod.
(2) Pull the control wire out of the push rod
while holding and catching the spring.
(3) Remove the hexagon head screw from the
bracket to free the control wire sheath.
(4) Release the knob on the dash by removing
the nut and washer attaching the knob and control
wire to the dash. Pull the control wire and knob
assembly out through the instrument panel in the
cab.