TM 9-2320-211-20
2-58. Turbocharger Oil Lines and Connections
(2) Unscrew the center bolt securing the rear
NOTE
a. Removal.
The bolt and housing are removed as an
(1) Disconnect the turbocharger lubrication
assembly.
line at the connection located on the upper section
(3) Remove and discard the filter element,
of the unit.
(2) Remove the bolt from the bracket securing
(4) Clean the filter housing, center bolt and
the turbocharger lubrication line to the manifold
seal seat, using drycleaning solvent or mineral
heater housing.
spirits paint thinner.
(3) Remove the lubrication line (drain) from
the pipe-to-tube adapter at the block.
Figure 2-63. Disconnecting lubrication lines at
turbocharger
-- m u l t i f u e l models.
b. Installation.
(1) Install the lubrication line to the pipe-to-
tube adapter at the block.
(2) Secure the line to the manifold heater
housing with the bracket and bolt.
(3) Connect the line to the upper section of the
unit.
b. Installation.
(1) Position a new seal and filter element on
the base plate.
fabrication of new tube assemblies.
(2) Assemble the center bolt on the filter
housing with a new gasket.
2-60. Crankcase Breather Tube
(3) Position the spring and cup on top of the
a. Removal.
element.
(1) Loosen the clamp that secures the hose to
(4) Attach the housing to the base with the
center bolt.
(5) Install the drain plug.
( 6 ) Add oil (LO 9-2320-211-12).
( 7 ) Start the engine and check for gasket
leaks.