TM 9-2320-366-20-4
16-27. ROOF HATCH REPLACEMENT (ALL MODELS EXCEPT M1093/M1094) (CONT)
b. Installation.
CAUTION
Begin inside and outside rubber strip
installation on opposite sides of each other.
Failure to comply may result in damage to
equipment.
(1) Install inside rubber strip (1) on roof hatch (2).
(2) Install outside rubber strip (3) on roof hatch (2).
(3) Install 6 in. (15.2 cm) back-up rubber strips (4)
centered on joints of inside and outside rubber
strips (1 and 3).
(4) Position roof hatch (2) on cab roof (5) with
matchmarks aligned.
(5) Position 12 washers (6) and screws (7) in roof hatch
(2).
(6) Tighten 12 screws (7) to 35-41 lb-ft (48-56 Nm).
WARNING
Adhesives,
solvents,
and
sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water. Failure
to comply may result in injury to
personnel.
(7) Apply 0.625 in. (1.5 cm) bead of sealing compound
to 12 screws (6) and between roof hatch (2) and
cab roof (5).
End of Task.
Change 2
