TM 9-2320-366-20-4
11-10. LOAD SENSING VALVE AND CONTROL CABLE REPLACEMENT/ADJUSTMENT
(CONT)
NOTE
If air chamber pressure is not within limits shown
perform steps (23) through (25), depress brake
pedal several times, shut down engine, and
perform steps (19) through (22) again.
Lengthening load sensing valve control cable
will increase pressure reading, shortening cable
will decrease pressure reading.
(23) Loosen screw (7) in cable clamp (1).
(24) Adjust length of load sensing valve control cable (6).
(25) Tighten screw (7) in cable clamp (1).
(26) Tighten jam nut (17) on screw (7).
(27) Shut down engine (TM 9-2320-366-10-1).
(28) Drain air from primary air tank (TM 9-2320-366-10-1).
(29) Disconnect test cable (16) from pressure transducer (15).
(30) Remove pressure transducer (15) from tee fitting (14).
(31) Disconnect air hose (9) from 90-degree fitting (10).
(32) Remove 90-degree fitting (10) from left rear service
brake air chamber (11).
(33) Disconnect center air hose (12) from 90-degree fitting
(13).
(34) Remove 90-degree fitting (13) from tee fitting (14).
(35) Remove tee fitting (14) from left rear service brake air
chamber (11).
11-68
Change 1