TM 9-2320-366-20-4
11-10. LOAD SENSING VALVE AND CONTROL CABLE REPLACEMENT/ADJUSTMENT
(CONT)
(2) Position control lever (2) so that it is level.
NOTE
It may be necessary to change location of
load sensing valve, bracket, and spacer on
crossmember in order to accomplish step (3).
(3) Position load sensing valve (3), bracket (4), and spacer
(5) so that load sensing valve control cable (6) is in
vertical position.
(4) Tighten screw (7) in cable clamp (1).
(5) Tighten two self-locking nuts (8) to 71-87 lb-ft (96-118
Nm).
(6) Disconnect air hose (9) from 90-degree fitting (10).
(7) Remove 90-degree fitting (10) from left rear service
brake air chamber (11).
(8) Disconnect center air hose (12) from 90-degree fitting
(13).
(9) Remove 90-degree fitting (13) from left rear service
brake air chamber (11).
(10) Install tee fitting (14) in hole from which 90-degree fitting
(13) was removed in step (9).
(11) Install 90-degree fitting (13) in tee fitting (14).
(12) Connect center air hose (12) to 90-degree fitting (13).
(13) Install 90-degree fitting (10) in left rear service brake air
chamber (11).
(14) Connect air hose (9) to 90-degree fitting (10).
(15) Install pressure transducer (15) in tee fitting (14).
(16) Connect test cable (16) to pressure transducer (15).
(17) Perform STE/ICE-R Test #50 (TM 9-4910-571-12&P).
11-66
Change 1
