TM 9-2320-366-20-3
WARNING
Adhesives,
solvents,
and
sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in a
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap
and water. Failure to comply may result in
injury to personnel.
(9) Apply thread sealant to 10 screws (12).
NOTE
Intermediate and rear spindle mounting bolts
are installed through the rear of hub
assembly.
(10) Position brake spider assembly (13), 10 washers
(14), and screws (12) on hub assembly (7).
(11) Tighten 10 screw (12) to 110-145 lb-ft (149-196 Nm).
NOTE
Step (12) applies to front spindles only.
(12) Connect two air hoses (15 and 16) to fittings
(8 and 9).
Change 2
10-29
