TM 9-2320-366-20-4
This task covers:
a. Inspection
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Materials/Parts
WARNING
Wear appropriate eye protection when working under vehicle due to the possibility of falling
debris. Failure to comply may result in injury to personnel.
a. Inspection.
(1) Place vehicle on level surface.
(2) Clean slip yoke (1) and shaft (2) with a dry rag.
(3) Mount dial indicator magnetic base (3) on bottom center
of slip yoke (1).
(4) Place dial indicator (4) 0.5 inches (12.7 mm) from slip
yoke seal (5).
(5) Push up on shaft (2) and adjust indicator (4) to zero.
(6) Pull down on shaft (2) and observe hinging reading.
(7) If reading is greater than 0.020 in. (0.508 mm), replace
(8) Remove dial indicator (3) from shaft (2).
End of Task.
All data on pages 9-6 through 9-8,
Change 1
including pages 9-7 and 9-8 deleted.