TM 9-2320-366-20-4
e. Installation.
WARNING
Do not use steel hammers to seat
bearing cups in drive yokes. Failure to
comply may result in injury to personnel
or damage to equipment.
CAUTION
Check bearing cups to ensure all needle
bearings are in place prior to installation.
Replace bearing cups if needle bearings are
missing or out of place. Failure to comply
may result in damage to equipment
NOTE
Wipe end of yoke bearing bores prior to
installation.
(1) Install two grease fittings (1) in universal joint (2).
NOTE
There are two types of bearing cups, those
with tabs and those without. Perform the
following step on bearing cups not
equipped with tabs.
(2) Position universal joint (2) on drive shaft (3) with
two bearing cups (4) and four screws (5).
NOTE
Perform the following step on kits equipped
with screws P/N C5H5-24-39.
(2.1) Tighten four screws (5) to 26-35 lb-ft (35-47 Nm).
Change 2
