TM 9-2320-366-20-4
9-2.
DRIVE SHAFT AND UNIVERSAL JOINT REPLACEMENT/REPAIR (CONT)
NOTE
Perform the following step on kits
equipped with shearhead screws.
When correct torque is reached, bearing
cap small screw hex head will break off.
(3) Tighten four screws (5).
NOTE
Perform the following two steps on bearing
cups equipped with tabs.
(3.1) Tighten four screws (5) to 26-35 lb-ft (35-47 Nm).
(3.2) Fould tabs on four screws (5).
(4) Deleted
CAUTION
Grease must flow from all four seals. Failure to
comply may result in damage to equipment.
(5) Apply lubrication to grease fittings (1).
(6) Perform steps (1) through (5) on opposite
end of drive shaft (3).
Change 2
